DataCard SR200 User Manual page 71

Menu Display Settings
IPv4 DHCP


Setting:
IP Address
Subnet Mask
Gateway
Effective IP
IPv6
Adrs Config


Setting:
IP Address
Prefix Len
SR200 & SR300 Card Printers and LM200 & LM300 Laminators User's Guide
ON
OFF
Auto
Manual
Function
Dynamic Host Configuration Protocol (DHCP) is a
network feature that assigns IP addresses to devices on
the network:
ON uses DHCP to assign the printer IP address. The

IP address can change when you power off the
printer and then power it on again.
OFF means that you must assign the IP address of

the printer and it will not change (static IP). Use this
setting if your network does not support DHCP.
Ask your network administrator which setting to use.
The default IP address of the printer is 192.168.0.141,
and is displayed when the printer is powered on for the
first time or when DHCP is set to On.
If you do not use DHCP, ask your network administrator
for the IP address to use.
The default subnet mask of the printer is
255.255.255.0. If you do not use DHCP, ask your
network administrator for the subnet mask.
The default gateway of the printer is 192.168.0.1. If
you do not use DHCP, ask your network administrator
for the subnet mask.
The IP address the printer uses.
Method to set the IP address if the network uses IPv6.
The printer does not have an default IPv6 IP address. If
Adrs Config is set to Auto and the printer is not
connected to a network, None is displayed.
The default prefix length is 64.
61