8.
The Mode (Back) menu displays next. To apply an additional
retransfer layer to the back of the card, press Change.
9.
Press the down arrow key once to change Line 2 to On and then
press
The success of the retransfer can vary depending on the card
material used. You may need to adjust the front and back speed of
retransfer to get an acceptable card.
Lowering the speed can enhance the retransfer, but the stronger heat that results may cause
the card to warp. Increase or decrease the speed values, as needed, to determine the best
retransfer results for your card type.
To change the speed values, continue with step
If you do not want to change the speed values, go to step
10.
Press Next to continue.
11.
The Speed (Front) menu displays next. To change the front speed,
press Change.
12.
Press the down arrow to change the speed and then press
accept the change.
13.
Press Next to continue.
14.
The Speed (Back) menu displays. To change the back speed, press
Change.
15.
Press the down arrow to change the speed and then press
accept the change.
16.
Press Exit three times to return the printer to Ready status.
17.
Print several test cards to test your settings and verify that the
retransfer film is being applied properly. Continue to adjust the
settings until you are satisfied with your cards.
SR200 & SR300 Card Printers and LM200 & LM300 Laminators User's Guide
to accept the change.
10.
16.
to
to
67