DataCard SR200 User Manual page 130

The following errors are detected by the printer driver and displayed in a message box.
Error Code Displayed Message
02****** Printer is not found.
0300274D Printer is not found.
0300374D
Printing to a USB‐connected printer
is not possible using an Ethernet
(LAN) connection.
03******
Printer is not found.
A communication error has
occurred.
04****** A communication error has
occurred.
09******
A command error has occurred.
0x10000103
An error has occurred during
magnetic encoding data writing.
10000201 Contact IC encoding program is not
found.
10000202 Unable to establish communication
with the contact IC encoder.
10000203 An error has occurred during
contact IC encoding data writing.
10000301 Non‐contact IC encoding program is
not found.
A-10
Solution
Make sure that the host PC and the printer

are connected properly.
Make sure that the printer is powered on.

Make sure that the host PC and the printer

are connected properly.
Make sure that the printer is powered on.

If the printer is set to USB and you

installed the network driver, uninstall the
driver and install the USB driver.
To print using an Ethernet (LAN) connection,
disconnect the USB cable from the printer.
Make sure that the host PC and the printer

are connected properly.
Make sure that the printer is powered on.

Verify that the computer settings are correct.
Verify that the card specifications are correct.
Contact your service provider or application
provider.
Contact your service provider.
Verify that the card specifications are correct.
Contact your service provider or application
provider.
Status Monitor Messages