Table of Contents
Advertisement
Deferred Transmissions: 0
Late Collisions: 0
Excessive Collisions: 0
Internal MAC Tx Errors: 0
Carrier Sense Errors: 0
Oversize Packets: 0
Internal MAC Rx Errors: 0
Received Pause Frames: 0
Transmitted Pause Frames: 0
The following table describes the fields shown in the display:
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision
Frames
Late Collisions
Excessive Collisions
Internal MAC Tx Errors
Oversize Packets
Internal MAC Rx Errors
Received Pause
Frames
Transmitted Pause
Frames
3.7.18 show ports jumbo-frame
The show ports jumbo-frame user EXEC command displays the jumbo frames configuration.
Description
Counted received octets.
Counted received unicast packets.
Counted received multicast packets.
Counted received broadcast packets.
Counted transmitted octets.
Counted transmitted unicast packets.
Counted transmitted multicast packets.
Counted transmitted broadcast packets.
Counted frames received that are an integral number of octets in length but do
not pass the FCS check.
Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
Counted times that a collision is detected later than one slotTime into the
transmission of a packet.
Counted frames for which transmission fails due to excessive collisions.
Counted frames for which transmission fails due to an internal MAC sublayer
transmit error.
Counted frames received that exceed the maximum permitted frame size.
Counted frames for which reception fails due to an internal MAC sublayer receive
error.
Counted MAC Control frames received with an opcode indicating the PAUSE
operation.
Counted MAC Control frames transmitted on this interface with an opcode
indicating the PAUSE operation.
55
Advertisement
Table of Contents
