Planet Networking & Communication WGSW-24010 User Manual page 231

• The port is not a VLAN member.
• Only one destination port can be defined.
The following restrictions apply to ports configured to be source ports:
• Source Ports cannot be a LAG member.
• Ports cannot be configured as a destination port.
• All packets are transmitted tagged from the destination port.
• Monitored all RX/TX packets to the same port.
?
When a port is set to be a target port for a port- mirroring session, all normal operations on it are
Note
:
suspended. This includes Spanning Tree and LACP.
To open Port Mirroring screen perform the folling:
1. Click Switch -> Ports -> Port Mirroring
2. The Port Mirroring screen is displayed as in Figure 3-54.
The page includes the following fields:
• Destination Port -- The port number to which port traffic is copied.
• Source Port -- Defines the port number from which port traffic is mirrored.
• Type -- Indicates if the source port is RX, TX, or both RX and TX.
• Status -- Indicates if the port is currently monitored (Active) or not monitored (Ready).
• Remove -- When selected, removes the port mirroring session.
Figure 3-54 Prot Mirroring screen
223