Show Ip Igmp Snooping Groups; Ip Addressing Commands; Clear Host Dhcp - Planet Networking & Communication WGSW-24010 User Manual

IGMP host timeout is 260 sec
IGMP Immediate leave is disabled. IGMP leave timeout is 60 sec
IGMP mrouter timeout is 300 sec
Automatic learning of multicast router ports is enabled

3.9.9 show ip igmp snooping groups

The show ip igmp snooping groups user EXEC command displays the multicast groups learned by IGMP snooping.
Syntax
show ip igmp snooping groups [vlan vlan-id] [address ip-multicast-address]
vlan_id — VLAN ID value.
§
§ ip-multicast-address — IP multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
To see the full multicast address table (including static addresses) use the show bridge address-table command.
Example
The example shows IGMP snooping information.
Console # show ip igmp snooping groups
Vlan IP Address
------- ------------------------------------- -------------
1 224-239.130|2.2.3
19 224-239.130|2.2.8

3.10 IP Addressing Commands

3.10.1 clear host dhcp

The clear host dhcp Privileged EXEC command deletes entries from the host name-to-address mapping received from
Dynamic Host Configuration Protocol (DHCP).
Syntax
clear host dhcp {name | *}
§ name — Particular host entry to remove. (Range: 1 - 160 characters.)
§ * — Removes all entries.
Default Configuration
This command has no default configuration.
Querier Ports
Yes e1, g2
Yes e9-11
------------
67