Planet Networking & Communication WGSW-24010 User Manual page 233

• Permanent -- The MAC address is permanent.
• Delete on Reset -- The MAC address is deleted when the device is reset.
• Delete on Timeout -- The MAC address is deleted when a timeout occurs.
• Remove -- When selected, removes the the MAC address from the MAC Address Table.
Dymanic Address Table
The Dynamic Address Table contains fields for querying information in the dynamic address table, including the interface
type, MAC addresses, VLAN, and table sorting. Packets forwarded to an address stored in the address table are forwarded
directly to those ports. The Dynamic Address Table also contains information about the aging time before a dynamic MAC
address is erased, and includes parameters for querying and viewing the Dynamic Address list. The Current Address
Table contains dynamic address parameters by which packets are directly forwarded to the ports.
To open Dynamic Address Table screen perform the folling:
1. Click Switch -> Address Table -> Dynamic Address Table
2. The Dynamic Address Table screen is displayed as in Figure 3-56.
The page includes the following fields:
• Address Aging (10-360) -- Specifies the amount of time the MAC Address remains in the Dynamic Address
Table before it is timed out if no traffic from the source is detected. The default value is 300 seconds.
• Interface -- Specifies the interface for which the table is queried. There are two interface types from which to
select.
• Port -- Specifies the port numbers for which the table is queried.
• LAG -- Specifies the LAG for which the table is queried.
• MAC Address -- Specifies the MAC address for which the table is queried.
• VLAN ID -- The VLAN ID for which the table is queried.
• Address Table Sort Key -- Specifies the means by which the Dynamic Address Table is sorted.
Figure 3-56 Dymanic Address Table screen
225