Show Ports Jumbo-Frame - Planet Networking & Communication WSGW-24020 User Manual

OutBcastPkts Counted transmitted broadcast packets.
FCS Errors Counted frames received that are an integral number of octets in length but do
not pass the FCS check.
Single Collision Counted frames that are involved in a single collision, and are subsequently
Frames transmitted successfully.
Late Collisions Counted times that a collision is detected later than one slotTime into the
transmission of a packet.
Excessive Collisions Counted frames for which transmission fails due to excessive collisions.
Internal MAC Tx Errors Counted frames for which transmission fails due to an internal MAC sublayer
transmit error.
Oversize Packets Counted frames received that exceed the maximum permitted frame size.
Internal MAC Rx Errors Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Received Pause Counted MAC Control frames received with an opcode indicating the PAUSE
Frames operation.
Transmitted Pause Counted MAC Control frames transmitted on this interface with an opcode
Frames indicating the PAUSE operation.

5.7.18 show ports jumbo-frame

The show ports jumbo-frame user EXEC command displays the jumbo frames configuration.
Syntax
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Console# show ports jumbo-frame
Jumbo frames are disabled
User's Manual of WGSW-24020/WGSW-48040
-20