3.
Toggle a port to F to forbid adding specific Multicast addresses to a specific port.
4.
Click Apply Changes.
The port is assigned to the Multicast group, and the device is updated.
Assigning LAGs to Receive Multicast Service
1.
Define the VLAN ID and the Bridge Multicast Address fields.
2.
Toggle the LAG to S to join the LAG to the selected Multicast group.
3.
Toggle the LAG to F to forbid adding specific Multicast addresses to a specific LAG.
4.
Click Apply Changes.
The LAG is assigned to the Multicast group, and the device is updated.
Bridge Multicast Forward All
The Bridge Multicast Forward All page contains fields for attaching ports or LAGs to a device that is attached to a
neighboring Multicast router/switch. Once IGMP Snooping is enabled, Multicast packets are forwarded to the appropriate
port or VLAN.
To open Bridge Multicast Forward All screen perform the folling:
1.
Click Switch -> Multicast Support -> Bridge Multicast Forward All
2.
The Bridge Multicast Forward All screen is displayed as in Figure 3-71
The page includes the following fields:
• VLAN ID -- Identifies a VLAN.
• Ports -- Ports that can be added to a Multicast service.
• LAGs -- LAGs that can be added to a Multicast service.
The following table contains the settings for managing router and port settings.
Port Control
Definition
D
Attaches the port to the Multicast router or switch as a dynamic port.
S
Attaches the port to the Multicast router or switch as a static port.
Figure 3-71 Bridge Multicast Forward All
245