Table of Contents
Advertisement
The page includes the following fields:
• Port -- The port number included in the VLAN.
• Port VLAN Mode -- The port mode. Possible values are:
• General -- The port belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q
mode).
• Access -- The port belongs to a single untagged VLAN. When a port is in Access mode, the packet types which
are accepted on the port cannot be designated. Ingress filtering cannot be enabled/disabled on an access
port.
• Trunk -- The port belongs to VLANs in which all ports are tagged (except for one port that can be untagged).
• PVID -- Assigns a VLAN ID to untagged packets. The possible values are 1-4094. VLAN 4095 is defined as per
standard and industry practice as the discard VLAN. Packets classified to the Discard VLAN are dropped.
• Frame Type -- Packet type accepted on the port. Possible values are:
• Admit Tag Only -- Only tagged packets are accepted on the port.
• Admit All -- Both tagged and untagged packets are accepted on the port.
• Ingress Filtering -- Enables or disables Ingress filtering on the port. Ingress filtering discards packets that are
destined to VLANs of which the specific port is not a member.
• Current Reserve VLAN -- The VLAN currently designated as the reserved VLAN.
• Reserve VLAN for Internal Use -- The VLAN that is designated as the reserved VLAN after the device is reset.
VLAN LAG Settings
The VLAN LAG Setting page provides parameters for managing LAGs that are part of a VLAN. VLANs can either be
composed of individual ports or of LAGs. Untagged packets entering the device are tagged with the LAGs ID specified by
the PVID.
To open VLAN LAG Settings screen perform the folling:
1.
Click Switch -> VLAN -> LAG Settings
2.
The VLAN LAG Settings screen is displayed as in Figure 3-64
Figure 3-63 VLAN Port Settings screen
235
Advertisement
Table of Contents
