Table of Contents
Advertisement
Command Mode
Line Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies a password "abc" on a line.
console (config-line) # password abc
3.3.9 enable password
The enable password global configuration command sets a local password to control access to normal and privilege
levels. To remove the password requirement, use the no form of this command.
Syntax
enable password [level level] password [encrypted]
no enable password [level level]
§
password — Password for this level, from 1 to 159 characters in length.
§
level level — Level for which the password applies. If not specified the level is 15 (Range: 1-15).
§
encrypted — Encrypted password entered, copied from another device configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a local level 15 password "abc" to control access to user and privilege levels.
console (config-line) # enable password level 15 abc
3.3.10 username
The username global configuration command establishes a username-based authentication system. To remove a user
name use the no form of this command.
Syntax
username name [password password] [privilege level] [encrypted]
no username
§
name — The name of the user.
password — The authentication password for the user, from 1 to 159 characters in length.
§
§
level — The user level (Range: 1 -15).
§
encrypted — Encrypted password entered, copied from another device configuration.
Default Configuration
The default privilege level is 1.
Command Mode
Global Configuration mode
17
Advertisement
Table of Contents
