Show Sflow Receivers - Enterasys SECURESTACK C3 Configuration Manual

show sflow receivers

For information about...
set sflow interface
show sflow interface
clear sflow interface
show sflow agent
show sflow receivers
Use this command to display the contents of the sFlow Receivers Table, or to display information
about a specific sFlow Collector listed in the table.
Syntax
show sflow receivers [index]
Parameters
index
Defaults
The contents of the sFlow Receivers Table is displayed.
Mode
Switch command, read‐only.
Usage
Executing this command without specifying an index into the sFlow Receivers Table displays
information about all the Collectors configured on the switch.
If you specify an individual Collector by its index number, additional information is displayed for
that Collector.
Examples
This example displays the sFlow Receivers Table.
C3(su)->show sflow receivers
Receiver Owner
Index
-------- -------- ---------- ------------ ----- -------------------
1
2
3
4
5
6
7
8
(Optional) Specifies a specific Collector to display information about.
Time out Max Datagram Port
String
ets1 17766
0
0
0
0
0
0
0
IP Address
Size
1400 6343 10.1.2.117
1400 6343 0.0.0.0
1400 6343 0.0.0.0
1400 6343 0.0.0.0
1400 6343 0.0.0.0
1400 6343 0.0.0.0
1400 6343 0.0.0.0
1400 6343 0.0.0.0
sFlow Configuration
Refer to page...
28-14
28-15
28-16
28-17
SecureStack C3 Configuration Guide 28-5