Clear Cos Port-Resource Irl - Enterasys SECURESTACK C3 Configuration Manual

clear cos port-resource irl

----------- -------- ---- ---- ----------
2.0
This example displays the flood control resources configured for group 1.0.
C3(su)->show cos port-resource flood-ctrl 1.0
'?' after the rate value indicates an invalid rate value
Group
Index
--------- -----------
1.0
1.0
1.0
clear cos port-resource irl
Use this command to clear inbound rate limit resources to default values.
Syntax
clear cos port-resource irl {all | group-type-index [irl-index [unit] [rate]
[type]]}
Parameters
all
group‐type‐index
irl‐index
unit
rate
type
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the data rate to 0 for IRL resource index 1 for group 2.0.
C3(su)->clear cos port-resource irl 2.0 1 rate
11-30 Policy Classification Configuration
1 irl kbps 10000
Resource Type
----------
ucast flood-ctrl
mcast flood-ctrl
bcast flood-ctrl
Clear all IRL resources for all port groups.
Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
(Optional) Inbound rate limiter resource index associated with the
specified port group. Valid values range from 0 to 99.
Clear the unit of measure for the inbound rate limiter.
Clear the data rate for this inbound rate limiter.
Clear the action for the rate limiter.
--------------- ------
drop
Unit Rate
---- ---------- ---------------
pps 20
pps 10
pps 5
none
Rate Limit Action
type
------
drop none
drop none
drop none