Clear Mirror Vlan - Enterasys SECURESTACK C3 Configuration Manual

Mode
Switch command, read‐write.
Usage
Refer to "Remote Port Mirroring" on page 7‐36 for information about configuring mirror VLANs.
Use the show port mirroring command to display the VLANs configured for remote port
mirroring.
Example
The following example assigns a VLAN for mirroring traffic and then shows the configured port
mirroring with the show port mirror command.
C3(su)->set mirror vlan 2
C3(su)->show port mirroring
Port Mirroring
==============
Source Port
Target Port
Frames Mirrored = Rx and Tx
Port Mirroring status enabled
Mirror Vlan

clear mirror vlan

Use this command to clear the VLAN to be reserved for mirroring traffic.
Syntax
clear mirror vlan vlan-id
Parameters
vlan‐id
Defaults
None.
Mode
Switch command, read‐write.
Example
The following example clears VLAN 2 from being used for remote port mirroring.
C3(su)->clear mirror vlan 2
= ge.1.1
= ge.1.10
= 2
Specifies the VLAN to be cleared. The ID can range from 2 to 4093.
clear mirror vlan
SecureStack C3 Configuration Guide 7-41