Clear Spantree Maxage; Set Spantree Fwddelay - Enterasys SECURESTACK C3 Configuration Manual

clear spantree maxage

clear spantree maxage
Use this command to reset the maximum aging time for a Spanning Tree to the default value of 20
seconds.
Syntax
clear spantree maxage
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally reset the maximum aging time:
C3(su)->clear spantree maxage

set spantree fwddelay

Use this command to set the Spanning Tree forward delay.
Syntax
set spantree fwddelay delay
Parameters
delay
Defaults
None.
Mode
Switch command, read‐write.
Usage
The forward delay is the maximum time (in seconds) the root device will wait before changing
states (i.e., listening to learning to forwarding). This delay is required because every device must
receive information about topology changes before it starts to forward frames. In addition, each
port needs time to listen for conflicting information that would make it return to a blocking state;
otherwise, temporary data loops might result.
Example
This example shows how to globally set the bridge forward delay to 16 seconds:
9-20 Spanning Tree Configuration
Specifies the number of seconds for the bridge forward delay. Valid values
are 4 ‐ 30.