Purpose; Commands; Show Port Mirroring - Enterasys SECURESTACK C3 Configuration Manual

show port mirroring

Port Mirroring
==============
Source Port
Target Port
Frames Mirrored = Rx and Tx
Port Mirroring status disabled
4. When you are ready to enable this instance, enter MIB option 1 (active) and perform an SNMP
Set operation.
5. (Optional) Use the CLI to verify the port mirroring instance has been enabled.
To delete a port mirroring instance:
1. Select a previously created port mirroring instance in your MIB browser.
2. Enter MIB option 6 (destroy) and perform an SNMP Set operation.
3. (Optional) Use the CLI to verify the port mirroring instance has been deleted as shown in the
following example:
C3(su)->show port mirroring
No Port Mirrors configured.

Purpose

To review and configure port mirroring on the device.

Commands

For information about...
show port mirroring
set port mirroring
clear port mirroring
set mirror vlan
clear mirror vlan
show port mirroring
Use this command to display the source and target ports for mirroring, and whether mirroring is
currently enabled or disabled for those ports.
Syntax
show port mirroring
Parameters
None.
Defaults
None.
7-38 Port Configuration
= ge.1.3
= ge.1.2
Refer to page...
7-38
7-39
7-40
7-40
7-41