Show Ipv6 Route Preferences; Show Ipv6 Route Preferences Output Details - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 route preferences

This command shows the preference value associated with the type of route.
Syntax
show ipv6 route preference
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Router user execution: C3(su)‐>router>
Usage
Lower numbers have a greater preference. A route with a preference of 255 cannot be used to
forward traffic.
The default preference value for static routes can be set with the ipv6 route distance command.
The distance for a specific static route can be set with the ipv6 route command.
Example
The following example shows the output of this command.
C3(su)->router#show ipv6 route preferences
Local
Static
OSPF Intra
OSPF Inter
OSPF Ext T1
OSPF Ext T2
OSPF NSSA T1
OSPF NSSA T2
Table 22‐3 provides an explanation of the command output.
Table 22-3 show ipv6 route preferences Output Details
Output Field
Local
Static
OSPF Intra
OSPF Inter
OSPF Ext T1
Note: The configuration of NSSA preferences is not supported in this release.
0
1
8
10
13
150
14
151
What It Displays...
Preference of directly-connected routes.
Preference of static routes.
Preference of routes within the OSPF area.
Preference of routes to other OSPF routes that are outside of the
area.
Preference of OSPF Type-1 external routes.
show ipv6 route preferences
SecureStack C3 Configuration Guide 22-27