Set System Utilization - Enterasys SECURESTACK C3 Configuration Manual

set system utilization

This example shows how to display the system's overall memory usage:
C3(ro)->show system utilization storage
Storage Utilization:
Type
---------------------------------------------------------------
RAM
Flash
This example shows how to display information about the processes running on the system. Only
partial output is shown.
C3(ro)->show system utilization process
Switch:1
TID
----------------------------------------------------------
c157930 ipMapForwardingTask
cc70000 RMONTask
ccb0b60 SNMPTask
d4847a0 tEmWeb
d4ca360 hapiRxTask
dec8600 lvl7TaskUtilMonitorTas
eb74120 bcmRX
eb7fbc8 bcmLINK.0
f00c9a0 bcmTX
f027648 bcmCNTR.0
f034858 bcmL2X.0
set system utilization
Use this command to set the threshold for sending CPU utilization notification messages.
Syntax
set system utilization threshold threshold
Parameters
threshold threshold
Defaults
The default threshold value is 80%.
Mode
Switch command, read‐write.
Usage
This command sets the percentage of system CPU utilitization that will cause a trap notification to
be sent. After the threshold has been exceeded, additional notifications will be sent once a minute
until the utilization has dropped back below the threshold.
Example
This example sets the CPU utilization threshold to 75%.
3-16 Basic Configuration
Description
RAM device
Images, Config, Other
CPU:1
Name
Specifies a threshold value in 1/10 of a percent. Valid range is 1 to 1000.
A value of 0 disables utilization notification messages.
Size(Kb) Available (Kb)
262144
31095
5Sec 1Min
3.60% 3.02% 3.48%
0.00% 0.00% 0.00%
34.80% 34.06% 31.78%
0.00% 0.03% 0.01%
3.20% 4.80% 5.00%
0.40% 0.40% 0.40%
2.00% 2.91% 4.48%
0.40% 0.22% 0.32%
0.00% 0.33% 0.53%
0.00% 0.00% 0.03%
0.00% 0.02% 0.04%
97173
8094
5Min