Set Logging Application; Show Logging Application Output Details - Enterasys SECURESTACK C3 Configuration Manual

Parameters
mnemonic
all
Defaults
If no parameter is specified, information for all applications will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display system logging information pertaining to the SNMP
application.
C3(ro)->show logging application SNMP
Application
---------------------------------------------
90
1(emergencies)
4(errors)
7(information)
Table 14‐2 provides an explanation of the command output.
Table 14-2 show logging application Output Details
Output Field
Application
Current Severity Level

set logging application

Use this command to set the severity level of log messages for one or all applications.
Syntax
set logging application {[mnemonic | all]} [level level]
(Optional) Displays severity level for one application configured for
logging. Mnemonics will vary depending on the number and types of
applications running on your system. Sample mnemonics and their
corresponding applications are listed in Table
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 14-3.
(Optional) Displays severity level for all applications configured for
logging.
Current Severity Level
SNMP
2(alerts)
5(warnings)
8(debugging)
6
3(critical)
6(notifications)
What it displays...
A mnemonic abbreviation of the textual description for
applications being logged.
Severity level at which the server is logging messages for the
listed application. This range (from 1 to 8) and its associated
severity list is shown in the CLI output. For a description of these
entries, which are set using the set logging application
command, refer to "set logging
set logging application
14‐3 on page 14‐8.
application" on page 14-7.
SecureStack C3 Configuration Guide 14-7