Set Cdp State - Enterasys SECURESTACK C3 Configuration Manual

Table 6-1 show cdp Output Details (Continued)
Output Field
CDP Authentication
Code
CDP Transmit
Frequency
Port
Status

set cdp state

Use this command to enable or disable the CDP discovery protocol on one or more ports.
Syntax
set cdp state {auto | disable | enable} [port-string]
Parameters
auto | disable |
enable
port‐string
Defaults
If port‐string is not specified, the CDP state will be globally set.
Mode
Switch command, read‐write.
Examples
This example shows how to globally enable CDP:
C3(su)->set cdp state enable
This example shows how to enable the CDP for port ge.1.2:
C3(su)->set cdp state enable
This example shows how to disable the CDP for port ge.1.2:
C3(su)->set cdp state disable
What It Displays...
Authentication code for CDP discovery protocol. The default of 00-00-00-00-00-00-
00-00 can be reset using the set cdp auth command. For details, refer to
auth" on page 6-4.
Frequency (in seconds) at which CDP messages can be transmitted. The default of
60 seconds can be reset with the set cdp interval command. For details, refer to
cdp interval" on page 6-4.
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Whether CDP is enabled, disabled or auto-enabled on the port.
Auto‐enables, disables or enables the CDP protocol on the specified port(s).
In auto‐enable mode, which is the default mode for all ports, a port
automatically becomes CDP‐enabled upon receiving its first CDP message.
(Optional) Enables or disables CDP on specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
ge.
1.2
ge.
1.2
CLI" on page 7-1.
SecureStack C3 Configuration Guide 6-3
set cdp state
"set cdp
"set