Show Spantree Operedge - Enterasys SECURESTACK C3 Configuration Manual

Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset ge.1.11 as a non‐edge port:
C3(su)->clear spantree adminedge

show spantree operedge

Use this command to display the Spanning Tree edge port operating status for a port.
Syntax
show spantree operedge [port port-string]
Parameters
port port‐string
Defaults
If port‐string is not specified, edge port operating status will be displayed for all Spanning Tree
ports.
Mode
Switch command, read‐only.
Example
This example shows how to display the edge port status for ge.2.7:
C3(rw)->show spantree operedge port ge.2.7
Port ge.2.7 has a Port Oper Edge of Edge-Port
Specifies port(s) on which to reset edge port status. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
ge.
1.11
Displays edge port operating status for specific port(s).
show spantree operedge
SecureStack C3 Configuration Guide 9-41