Installing Ram - Canon LBP5360 User Manual

Installing RAM

An expansion RAM module is to be installed on the main board at the rear side of
the printer. A Phillips screwdriver is required for installing a RAM module. Have a
screwdriver ready in advance that matches the size of the screws. Observe the
following guidelines when installing RAM.
WARNING
Be sure to turn the printer OFF, unplug the power plug, and then disconnect all
the interface cables and power cord from the printer before installing RAM. If
you attempt to install RAM when the printer is ON or any cable is connected to
the printer, this may result in an electrical shock.
CAUTION
Be careful when handling a RAM module. Touching the edges or a sharp portion
of a RAM module may result in personal injury.
IMPORTANT
• A RAM module contains components that are sensitive to static electricity. Observe the
following precautions when handling a RAM module to prevent damage from static
electricity.
- Touch a metal object to dissipate static electricity before handling a RAM module.
- When handling a RAM module, do not touch anything that generates static electricity
such as the computer display.
- Do not touch the main board parts, printed wire, or connectors with your hands.
- To prevent the RAM module from being affected by static electricity, keep it in the
protective bag until it is ready to be installed.
• Be sure not to touch the switches on the main board. If you change the switches, the
printer does not operate properly.

Installing RAM

9-15
9