Canon LBP5360 User Manual page 339

Remedy 5 Change the setting for HALFTONES (See p. 6-38) in the QUALITY MENU
Remedy 6 Install an optional expansion RAM module, then print again. (See "Installing
<41 CHK PAPER SZE>
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cause 4
8
Remedy
<52 RAST.MODE ERR>
Cause
Remedy 1 The printer continues printing by pressing the
Remedy 2 Print again using a printer driver that supports image data formats.
<53 SEC.PRINT ERR>
Cause 1
Remedy
8-40 Message List
options in the SETUP menu, and then print again.
RAM," on p. 9-15)
The size of the paper loaded in the multi-purpose tray or paper cassette is
different from the setting for TRAY PAPER SIZE or CASSETTE(n) SIZE (n = 1,
2) specified from the computer or control panel.
Match the size specified in TRAY PAPER SIZE (See p. 6-22) or CASSETTE(n)
SIZE (n = 1, 2) (See p. 6-23) and the size of the loaded paper, and then press
the (Online) key.
You are using UFR II Printer Driver, and you loaded custom paper of its long
edges 215.9 mm or less in portrait orientation and printed when TRAY PAPER
SIZE or CASSETTE(n) SIZE (n = 1, 2) was set to MIXED SIZES.
Load the paper in landscape orientation, then print again.
When UFR II Printer Driver was not used, custom size paper was loaded in
landscape orientation to print.
Load the paper in portrait orientation, then print again.
SPECIAL MODE J in the USER MAIN. options in the SETUP is set to OFF.
Set SPECIAL MODE J (See p. 6-52) to ON, then print again.
The printer received data in format that it does not support during printing in the
Raster mode.
data may not be printed properly.
Secured print data is sent from a printer driver that is not for LBP5360.
Press the (Online) key to cancel the job.
<Auto Error Skip>
(Online) key. However, the
<Auto Error Skip>