Canon LBP5360 User Manual page 360

Cause 2 Toner may not fix onto paper completely depending on the paper type.
Remedy Set [Gray Compensation] to [On] in the printer driver.
In order to specify the setting for [Gray Compensation], display the following
dialog box.
- For UFR II Printer Driver: Display the [Advanced Settings] dialog box by
clicking [Details] in the [Quality] sheet, then clicking [Advanced Settings] in the
[Detailed Settings] dialog box.
- For PCL Printer Driver: Display the [Detailed Settings] dialog box by clicking
[Details] in the [Quality] sheet.
Cause 3 A problem has occurred inside the printer.
Remedy 1 If <Ennn-nnnn> is displayed in the display, turn the power OFF, wait for 10
seconds or longer, and then turn the power ON again. This may clear the
message.
Remedy 2 If the message does not disappear even after applying the Remedy 1, contact
your local authorized Canon dealer for servicing.
The printed colors appear different from those printed by another LBP5360 being used at the
same time.
Cause The default setting of the toner density of K (Black), Y (Yellow), M (Magenta), or
C (Cyan) is somewhat varied.
Remedy Adjust the toner density of K (Black), Y (Yellow), M (Magenta), or C (Cyan). (See
"Adjusting the Color Balance," on p. 8-67)
IMPORTANT
Adjustment of the toner density affects all the color print jobs. Normally, use the printer
with the toner density left to the default value (8).
Data is not printed in correct colors or colored text appears to be blurred due to a
phenomenon of "Out-of-Register Colors".
Cause 1 The toner cartridges are not installed properly.
Remedy Check if the toner cartridges are installed properly. (See "Replacing Toner
Cartridges," on p. 7-2)
Cause 2 Any of the four color toner cartridges is almost out of toner, or the drum in any of
the toner cartridges has deteriorated.
Remedy 1 Adjust the phenomenon of "Out-of-Register Colors" in CALIBRATION (See p.
6-63) in the UTILITY menu.
When You Cannot Obtain Appropriate Printout Results
8
8-61