Canon LBP5360 User Manual page 337

Remedy 2 After turning the printer OFF, restore the memory to the original condition
Remedy 3 Set EXT.RX BUFFER (See p. 6-51) in the INTERFACE MENU options in the
<32 2-SIDED ERROR>
Cause
Remedy 1 The printer continues printing by pressing the
Remedy 2 After performing a soft reset in the RESET menu, change the setting to a paper
<33 WORK MEM.FULL>
Cause
Remedy 1 The printer continues printing by pressing the
IMPORTANT
When you continue printing by pressing the
8
macro that is already registered may be deleted.
Remedy 2 Perform a soft reset in the RESET menu, increase the free space of RAM using
<35 TABLE FULL>
Cause
Remedy
8-38 Message List
(install the removed RAM), and then print again. (See "Installing RAM," on p.
9-15)
SETUP menu to OFF, and then print again.
The printer received 2-sided printing data of paper sizes (including the
orientation) or paper types unavailable for automatic 2-sided printing.
data on each side is printed on two pages.
size or type available for automatic 2-sided printing, and then print again.
The work memory for each operation mode cannot be secured.
data with which an error has occurred is not printed properly.
the following procedure, and then print again.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
• If you are using UFR II Printer Driver, install an optional expansion RAM
module. However, the problem may not be solved even after the expansion
RAM module is installed. (See "Installing RAM," on p. 9-15)
The number of the documents in a job has exceeded 16.
The printer continues printing by pressing the
job with which an error has occurred is not printed.
<Auto Error Skip>
(Online) key. However, the
<Auto Error Skip>
(Online) key. However, the
(Online) key, be aware that the data of
<Auto Error Skip>
(Online) key. However, the