■ APPLETALK
6
■ SMB
■ SNMP
6-48
SETUP Menu Settings
NOTE
To enter a numeric value for IP ADDRESS, SUBNET MASK, or GATEWAY
•
ADDRESS, press [
] or [
by periods to enter three-digit numbers) in which you want to enter respective
values of the address. The numbers in the field blinks, allowing you to enter the
value. Pressing [
] increases the value and [
entering values in all the fields, press [OK] to confirm the setting.
For more details on the setting, see "Chapter 3 Using the Printer on a TCP/IP
•
Network (Windows/UNIX)" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
OFF*, ON
Specifies whether the printer should use AppleTalk.
NOTE
For more details on AppleTalk, see "Chapter 6 Using the Printer on an AppleTalk
•
Network (Macintosh)" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
SMB SERVER...................... OFF*, ON
1
SMB*
.................................. OFF*, ON
*1 SMB is displayed only when an optional hard disk is installed, HARD DISK is set to ON, and SMB
SERVER is set to ON.
Specifies whether the printer should use the SMB protocol.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
ON*, OFF
Specifies whether the printer should use the SNMP protocol.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
] to move the cursor to each field (an area separated
] decreases the value. After