Canon LBP5360 User Manual page 73

NOTE
• This printer recognizes the type of Ethernet (100BASE-TX or 10BASE-T) automatically.
• If both 100BASE-TX devices and 10BASE-T devices are on the same network, a device
such as a switching hub that supports both 100BASE-TX and 10BASE-T is required. For
more details, contact your local authorized Canon dealer.
• If you connected this printer to a network, check the MAC address of the print server with
Configuration Page Print, and then configure the network operating system (UNIX, etc.)
and print server. For more details, see "Network Guide".
2
1
2-30 Connecting the Cables
Attach the ferrite core to the LAN cable as shown in the figure.
Attach the ferrite core at 5 cm or less from the end of the connector (A)
connected to the printer.
(A)
NOTE
A ferrite core is supplied with the printer.
5 cm or less