Canon LBP5360 User Manual page 361

Remedy 2 Replace the toner cartridge of the color for which <PREP."color" TNR>, <CHK
Cause 3
Remedy
Cause 4
Remedy
NOTE
• When AFTER JOBS is selected in 1ST CALIBRATION (See p. 6-56) in the USER MAIN.
options in the SETUP menu, calibration is performed at the completion of the first printing
after the printer is turned ON.
• If you want to perform calibration, see "UTILITY Menu Settings," on p. 6-62.
The colors of thin lines or filled-in patterns are different from the specified colors, or do not
appear at all.
Cause 1
Remedy 1 Adjust the colors in the application and print again.
8
Remedy 2 Change the patterns in the application and print again.
Cause 2
Remedy 1 Readjust to a darker color and print again.
Remedy 2 Reload paper to change the feeding direction, then print again.
Fill-patterns are not printed in the correct color (specified color).
Cause
Remedy 1 Print again without specifying a fill-pattern in the application.
Remedy 2 Set [Color Halftones], [B & W Halftones], or [Halftones] to [Gradation] or [Color
8-62 When You Cannot Obtain Appropriate Printout Results
"color" TNR>, or <CHG."color" TNR> is indicated with a new one. (See
"Replacing Toner Cartridges," on p. 7-2)
Appropriate paper is not being used.
Replace the paper with one that can be used and print again. (See "Paper
Requirements," on p. 4-2)
Data was sent before completing calibration, such as when the printer was first
turned ON.
Confirm that <00 READY> is displayed in the display, then print again.
Some colors cannot be reproduced due to the combination of colors or
patterns.
The color may appear different depending on the fill-pattern.
The fill-pattern of the print data and the dither pattern of the printer are
interfering with one another.
Tone] in the printer driver.
In order to specify the setting for [Color Halftones], [B & W Halftones], or
[Halftones], display the [Detailed Settings] dialog box by clicking [Details] in the
[Quality] sheet.