■ SPOOLER
OFF*, ON
Specifies whether the printer should use the Spooler function.
NOTE
For more details on the Spooler function, see "Chapter 2 Common Network
•
Settings" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON, an optional hard disk is installed, and HARD DISK is set to ON.
■ START WAIT TIME
0 to 300 seconds; 0 seconds*
Specifies the time interval from when the printer is turned ON to when the protocol
starts.
NOTE
For more details on startup waiting time, see "Chapter 2 Common Network
•
Settings" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
■ REMOTE UI SET.
REMOTE UI ..........................ON*, OFF
1
SSL*
....................................OFF*, ON
*1 SSL is displayed only when an optional hard disk is installed, and HARD DISK is set to ON.
Specifies whether the printer should use the Remote UI.
NOTE
For more details on SSL, see "Chapter 2 Common Network Settings" in Network
•
Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
■ ETHERNET DRIVER
AUTO DETECT.....................ON*, OFF
1
COMM.MODE*
....................HALF DUPLEX*, FULL DUPLEX
ETHERNET TYPE*
MAC ADDRESS....................(Display only)
*1 COMM.MODE and ETHERNET TYPE are displayed only when AUTO DETECT is set to OFF.
Configures the Ethernet driver.
1
.............10 BASE-T*, 100 BASE-TX
SETUP Menu Settings
6
6-49