Menu Operations And Menu List; Menu Operations - Roland V-1600HD Owner's Manual

Menu Operations and Menu List

Menu Operations

The system settings menu for the V-1600HD is displayed on the monitor. Menu operations follow the flow described below.
1.
Display the desired menu.
Press the button in the SETUP section to display the target menu. The pressed button lights up.
fig.menu-open.eps
2.
Select the menu item whose setting you want to change.
Press the [CURSOR] buttons to choose the menu item whose setting you want to change. When a triangular symbol is displayed
at the top of the screen, you can use the left and right [CURSOR] buttons to change the page ahead or back. To select an item, use
the up and down [CURSOR] buttons.
fig.select-fix.eps
3.
Change the setting value.
If the displayed setting value is highlighted, you can change the value by turning the [VALUE] dial. If the displayed setting value is
[ENTER], use the [ENTER] button to go into the lower level to change value.
fig.change-value.eps
* You can change a setting value up or down by 10 units at a time by holding down the [ENTER] button and turning the [VALUE] dial.
* You can also return a setting value to its factory default by holding down the [ENTER] button and pressing the [EXIT] button.
4.
Exit the menu.
You can exit the menu screen by pressing the [EXIT] button. Exiting the menu makes the button you pressed in step 1 go dark.
fig.close-menu.eps
The setting value is not stored in internal memory unless it is saved to a [MEMORY] button. Refer to "Saving Settings to MEMORY Buttons" (p. 53)
and save the settings before turning off the power.
47