Outputting A Still Image - Roland V-1600HD Owner's Manual

Outputting a Still Image

On the V-1600HD, you can load a still-image file from a USB memory device and assign it to channel 14 or channel 1 through 8.
To use a still-image file, you must first load it from a USB memory device.
* The V-1600HD can load only still-image files that are 24-bit bitmap (.bmp) images up to 1,920 x 1,200 pixels in size.
* The number of images that the V-1600HD can load ranges from one to four. The number varies according to the size of the bitmap images.
The V-1600HD cannot display still images at reduced size.
The format of still image should match your preferred V-1600HD output format.
1.
Save the still-image file on a USB memory device.
Save the still-image file on a USB memory device formatted on the V-1600HD in advance. Use a file name containing no more
than eight single-byte alphanumeric characters. Also, save the file in the root directory of the USB memory device.
2.
Connect the USB memory device.
Connect the USB memory device to the USB MEMORY port on the side of the monitor.
fig.connect-USB.eps
3.
Display the SYSTEM menu.
Go to the SETUP section and press the [SYSTEM] button to display the SYSTEM menu.
fig.system-button.eps
4.
Access the menu for capturing still-image data.
Use the [CURSOR] buttons to choose [Still Image], then use the [ENTER] button to apply the selection. The unit changes to the
menu for loading a still image.
fig.load-file-menu.eps
40