Roland V-1600HD Owner's Manual page 42

Outputting a Still Image
9.
Confirm input on channel 14.
Press the left and right [CURSOR] buttons to change the page and display [Ch. 14]. Make sure the source is in a state allowing it to
be changed (Selectable).
* When this is set to [Locked], the assignment cannot be changed. In this case, use the up and down [CURSOR] buttons to choose [Locked], then
turn the [VALUE] dial to change the setting to [Selectable].
fig.still-assign.eps
10.
Change the assignment for channel 14.
Press the up and down [CURSOR] buttons to choose [BACKGROUND]. Turn the [VALUE] dial to change the assignment from
[BACKGROUND] to [STILL IMAGE]. Press the [EXIT] button to exit the menu.
fig.assign-stills.eps
11.
Put channel 14 on standby.
Go to the PST/EFFECT section and press the button for channel 14 to place the still image on standby. If the display mode for the
monitor is set at PVW, the still image appears on the monitor.
fig.14-channel.eps
12.
Output channel 14.
Press the [TAKE] button or move the video fader to output channel 14. The final output of the V-1600HD changes to the still
image.
fig.take-Tbar.eps
You can use the same procedure as in steps 8 through 10 above to assign a still image to channels 1 through 8 as well.
Still-image files are not saved in the V-1600HD's internal memory, and the unit reverts to the state before image loading when the power is
turned off. However, the procedure described below saves the file name, and the file is loaded automatically at the time of the next startup.
• At the [System] menu, go to the [Memory Story Parameters] item and set [Still Image] to [ON].
• Save the data to the MEMORY button 1 in BANK1 (p. 53).
• Connect the same USB memory device to the V-1600HD and start the V-1600HD.
* If the still image file with exactly the same file name does not exist in the USB memory connected to V-1600HD, the file cannot be loaded with
the above procedure.
42