Troubleshooting - Roland V-1600HD Owner's Manual

Appendices

Troubleshooting

S-Video input is not displayed.
Is composite assigned to channel 13?
Refer to "Connecting SD Analog Video Equipment (S-Video)" (p. 19) and change the assignment for channel 13 from [COMPOSITE]
to [S-VIDEO].
DVI-D input is not displayed.
Is RGB/Component assigned to channels 11 and 12?
Refer to "Connecting a Computer (DVI-D)" (p. 21) and change the assignment for channels 11 and 12 from [RGB/COMPONENT] to
[DVI-D/HDMI].
* Same change of assignment is required when HDMI equipment is connected.
Analog-component input is not displayed.
Are the input signals Y/Pb/Pr?
Y/R-Y/B-Y input to the V-1600HD's RGB/COMPONENT connector is not possible.
Output from the computer is not accepted.
Are the computer's output resolution and refresh rate set correctly?
At "Main Specifications" (p. 63), refer to "Supported Formats" and set the computer to perform output in a format that the V-
1600HD supports.
Input is in a supported format, but output is not displayed.
Is the input format restricted by the [Format] item at the INPUT menu?
Selecting [Auto] enables support for all inputtable formats. Selecting an item other than [Auto] limits the formats that can be
input.
Correct thru-out sending of component input is not displayed.
Is the [TERMINATOR] switch next to the RGB/COMPONENT IN connector set to [ON]?
You set this to [ON] when terminating RGB or component input at the V-1600HD, and set it to [OFF] for thru-out.
Colors are not displayed correctly.
If you are using component cables, are the Y/Pb/Pr connectors connected in right order ?
Has the mode setting for color space been made correctly?
On the V-1600HD, you can make color-space settings for input channels 9 through 12 and for DVI-D output. When the color space
of connected equipment is not clear, setting the value to [Auto] is recommended.
64