NEC Express 5800 User Manual page 118

Hardware
The following table shows LED status and its description.
Off
(1) Lighting in green
Lighting in amber
Off
(2)
Lighting in green
Off
(3)
Lighting in blue
Off
(6)
Lighting in green
Off
(5)
Lighting in green
(7)
Blinking in green
Off
(4)
Lighting in green
(8)
Lighting in amber
(10)
Off
(9)
Lighting in green
(11)
Blinking in green
*1 This LED may not exist. Please refer to Status LED.
Supplementary note
LAN Status LED (LINK/ACT LED)
This displays each network port status, and lights in green (LINK) while electrical power
is supplied to the server and HUB and they are connected normally. This blinks in green
(ACT) while the network port is transmitting/receiving.
Check the network cable status and cable connection status if the LED does not light
even in the LINK state. The network (LAN) controller may have failed if the LED does
not sill light. Contact the distributer from which you purchased or maintenance support
company.
LAN Speed LED (100/10 LED)
This LED indicates which of network interfaces is used by communication mode of the
network port. lighting in green indicates that 100 Mbps is used. LED that is off indicates
that 10 Mbps is used.
LAN Speed LED (1000/100/10 LED)
This LED indicates which of network interfaces is used by communication mode of the
LED Status
Management module is not operating
Normal management module
Abnormal management module
Abnormal management module *1
Normal management module *1
Normal
Lights when checking the position of the server
Indicates that network communication with 10 Mbps is
possible
Indicates that network communication with 100 Mbps is
possible
Indicates Link down
Indicates Link up
Indicates the state of being transmitted/received
Indicates that network with 10 Mbps is allowed
Indicates that network with 100 Mbps is allowed
Indicates that network with 1000 Mbps (1Gbps) is
allowed
Indicates Link down
Indicates Link up
Indicates the state of being transmitted/received
Description
: (5), (7), (9), (11)
: (6)
: (4),(8), (10)
118