Supported Standard Commands; General Description - NEC Express 5800 User Manual

Supported Standard Commands

General description

The following standard SMASH-CLP commands defined by DMTF specification are supported
by the management firmware.
Command Function
cd Move to the target.
dump Move the dump from the memory map to the URI.
Used for saving SG Information.
exit Terminate the CLP session
Display the help menu
help
Move the binary image from the URI to the memory map.
load
Used for restoring SG Information and updating the firmware.
reset Power OFF the target compulsory.
set Set the value to the target property.
show Display the target property and contents such as settings for
the network or user account
start Power ON the target
stop Shut down OS for the target
version Display the version of SMASH-CLP
IMPORTANT:
•The interruption of the command by CTRL + C is not
supported. However there are some exceptions.
NOTE:
•The operations for SMASH-CLP is similar to the one of Linux or
UNIX. For example, the "show"" command is equivalent to
"ls" for Linux and UNIX. The target is equivalent to the
directory for Linux and UNIX.
•The prompt for SMASH-CLP is "->".
528
Privilege
Operator
Administrator
Operator
Operator
Administrator
Operator
Operator
Operator
Operator
Operator
Operator