Hardware
DVD Drive
Your server is provided with the DVD drive on its front.
Setting/Removing the CD/DVD-ROM
Set a disk on the DVD drive in the following procedure.
1. Confirm that the power of the server is on before setting the CD/DVD-ROM on the DVD
drive.
2. Press the media tray eject button on the
front of the DVD drive.
The tray comes out.
3. Hold the CD/DVD-ROM with its signal side
Facing the tray.
4. Press the disk with fingers to make the hole of
the disk fit to the rotor at the center of the tray.
CAUTION
Observe the following instructions to use the server safely. There are risks
of fire, personal injury, or property damage. Refer to descriptions after
page iii for details.
● Do not leave the tray of optical drive device ejected
Drive Shaft
Press this part of
a disk medium.
170
.