NEC Express 5800 User Manual page 358

Hardware
3. Upon completion of selection, select [Add to Array] at the lower right of the screen and
press Enter. After making sure that the new DG has defined in Disk Groups frame to the
right, select [Accept DG] and press Enter.
4. A new DG is defined in the Disk Groups frame. Define another DG in the similar
procedures. After DGs have been defined, select [Next] at the lower right of the screen
and press Enter.
5. Configure RAID10 (spanning of RAID1) using the two DGs that have been created in
previous step. When DGs were defined, [VD Definition] screen is displayed.
358