Enable/Disable Component - NEC Express 5800 User Manual

2.10.1 Enable/Disable Component

Enable/Disable Component is displayed by selecting "Fault Information" and clicking
"Enable/Disable" of the menu on the left side of the screen.
Hardware unit status (Enable/Disable) can be checked and Enable/Disable setting can be
performed manually in Enable/Disable Component.
(2)
(1) Display/set Enable/Disable status.
Displayed contents are as follows.
Setting
Name
(2) Clicking "Submit" enables to set the information of (1).
(3) Clicking "Cancel" enables to move to Fault Information screen.
(3)
: Enable/Disable status
: Disable sensor name
IMPORTANT:
 If the non-redundant hardware unit is set to "Disabled", the
server cannot be booted.
 If the hardware unit which has previously set to "Disabled" is
set to "Enable" at the time of failure, the same hardware unit
failure may reoccur it may temporarily recover.
489
(1)