Unmounting Procedure - NEC Express 5800 User Manual

Hardware

Unmounting Procedure

Ensure to use a lifter or carry with 4 or more persons when unmounting the server from the rack.
1. Check that the power of the server is turned OFF before removing all power codes and
interface cables connected to the server.
2. Install a tip-resistant stabilizer to the bottom front of the rack.
3. Lessen screws fixing the server located on each front side.
4. Hold the handle and pull out from the rack slowly and gently. It is latched when it clicks.
CAUTION
Observe the following instructions to use the server safely. There are risks
of fire, personal injury, or property damage. Refer to descriptions after
page iii for details.
● Ensure to use a lifter to lift the server and support the bottom of the
server firmly to install or relocate it. If there is no lifter, carrying the server
by less than 4 persons may cause backache.
● Do not install the server in other than the location specified.
● Do not get your fingers caught.
● High temperature
● Do not unmount the server when the rack is unstable.
● Do not leave the multiple servers being pulled out from the rack.
150