NEC Express 5800 User Manual page 392

(2) Clicking "Submit" enables to set the time and date with the information of (1).
(3) Selecting "Set NTP Server Setting" enables to set time and date using NTP server.
(3)-1 Set IP address of NTP server in "NTP Server IP."
Set the address in dot-decimal notation to IP address.
Dot-decimal notation: xxx.xxx.xxx.xxx (0-255)
(3)-2 Set UTC offset value(from -24 to +24、and operator designated value) in "Universal
Time(UTC)Offset". This value is used to set the GMT time which is obtained from the
designated NTP server as the local time of system. As for the custom setting, please refer
to (1)-3.
(4) Clicking "Submit" enables to set the information of (3).
IMPORTANT:
 If specified time is significantly different from current time, it
may affect to the Management Firmware(disconnection of SOL
session, poweron failure or aborting of maintenance mode).
 (3)-1 If the NTP Server IP is specified, NTP setting is regarded
as valid. If it is a blank, the NTP setting is regarded as invalid.
 An operator can change date and time of MGM, but it is not
displayed.
 Universal Time(UTC)Offset is reflected to the MGM local time
and the SEL timestamp which are managed by the Management
Firmware.
392