NEC Express 5800 User Manual page 13

Installation, Relocation, Storage, and Connection
Do not install your server on a rack without its cover.
Failure to follow this instruction may reduce the cooling effect in the server, resulting in
some malfunction and/or dust entering the server, and resulting in a fire or electric
shock.
Do not install the server in any place other than specified.
Do not install the server in the following places or any place other than specified in this
manual. Failure to follow this instruction may cause a fire.
■ a dusty place
■ a humid place such as near a boiler
■ a place exposed to direct sunlight
■ an unstable place
Do not pinch your finger with rails or other components.
Note sufficiently that your fingers may not be caught between a rail and another
mechanical part or cut by a rail at installation or removal of the server from the rack.
Do not connect any interface cable with the power cord of the server plugged to a
power source.
Make sure to power off the server and unplug the power cord from a power outlet
before connecting/disconnecting any interface cable to/from the server. If the server is
off-powered but its power cord is plugged to a power source, touching a cable or
connector may cause an electric shock or a fire resulted from a short circuit.
Do not use any unauthorized interface cable.
Use only interface cables provided by NEC and locate a proper device and connector
before connecting a cable. Using an authorized cable or connecting a cable to an
improper destination may cause a short circuit, resulting in a fire. Also, observe the
following notes on using and connecting an interface cable.
■ Do not use any damaged cable connector.
■ Do not step on the cable.
■ Do not place any object on the cable.
■ Do not use the server with loose cable connections.
■ Do not use any damaged cable.
xiii