Memory Switch Adjustment; Setting The Memory Switches; Clearing The Memory Switches - Muratec MFX-1300 Field Engineering Manual

3.3 Memory Switch Adjustment

3.3.1 Setting the Memory Switches

These switches are used to program internal machine parameters. The primary back up battery maintains
these settings if power is lost.
1. From standby, press Program key, *, 1.
Set Memory Switch
2. Press ENTER.
A0:
3. Select the desired memory switch by pressing a one-touch key plus a number on the keypad. For example,
to access memory switch B:1, press one-touch "B" plus the number "1" on the numeric keypad.
B1:
4. Press ENTER.
Set Memory Switch
B1
Bit No.
(The bits are numbered 7 through 0 - - - bit 7 is left most.)
5. To navigate through the memory switch settings:
Press key to move the cursor to the left.
Press to move the cursor to the right.
Press the 0 or 1 on the numeric keypad to change the bit value.
Press ENTER to save the setting of the displayed memory switch and advance to the next memory
switch.
(Continue pressing ENTER until the desired memory switch is shown in the display. Be sure to press
ENTER after each memory switch is programmed to save the new setting.)
Press STOP to return the unit to standby.
Note: You can confirm the initial setting of each Memory Switch by the Memory Switches List.
The Memory Switches List will be printed by pressing Program key, *, A(01).

3.3.2 Clearing the Memory Switches

Resets the memory switches to factory defaults.
1. From standby, press Program key, *, 1,
Clear Memory Switch
2. Press ENTER.
Clear Memory Switch
Check Enter/Cancel
3. Press ENTER. The memory switches will reset to factory defaults.
Note: To finish the operation without clearing the memory switches, press CANCEL.
/ /Enter
00000110
/ /Enter
01001011
/ /Enter
01001011
76543210
.
/ /Enter
3-18