Quick Initial Settings (Only For Mfx-1700/Mfx-1300) - Muratec MFX-1300 Field Engineering Manual

3.21 Quick Initial settings (Only for MFX-1700/MFX-1300)

At installation of this machine, you should set some parameters according to the following procedures.
You can do the following setting with continuously.
1. Initial settings
2. Consumable order sheet settings
3. Service report settings
Note: Before starting the installation settings, clear the memory by pressing Program, *, 2, ENTER.
Entering initial settings (Program, *, W)
1-1. To start Initial setting mode, press Program, *, W. The LCD shows:
Language :English
!/"/Enter
Press ! or " until the language you want appears, then press ENTER to save the language setting
1-2.
and continue.
1-3. The LCD now shows the calendar/clock setting, with a cursor appearing on the first digit.
Enter Time
01/01 01 '00:00
1-4. Use the cursor key and numeric keypad to enter the correct date and time.
For USA version, using a mmddyy format for the date and 24-hour format for the time.
For GBR version, using a ddmmyy format for the date and 24-hour format for the time.
For instance, to set 2:30 pm on January 09, 2002:
USA version, press 0 1 0 9 0 2 1 4 3 0
GBR version, press 0 9 0 1 0 2 1 4 3 0
1-5. Press ENTER to save the clock setting and continue.
1-6. The LCD now asks if you want to set the calendar/clock to automatically recognize daylight saving time
(DST).
Note: This will appear only for USA version.
Daylight Saving :Off
!/"/Enter
When the setting is ON, your machine automatically recognizes DST at 2 am on the appropriate
switchover Sundays each year.
When the setting is OFF, no automatic change will occur.
Press ! or " until the mode you want appears, then press ENTER to save the setting and continue.
1-7.
3-84