Muratec MFX-1300 Field Engineering Manual page 90

Unique Switch h:3 - Operation
Initial
Switch
Setting
7 0 Priority of consumable order
sheet printing
1: Print immediately
0: Print after the current
printing job completed
6 0 Factory use only
5 0 Factory use only
4 0 Continuous polling function
0: No
1: Yes
3 0 Factory use only
2 0 Factory use only
1 0 Auto answer On/Off can be
selected for Soft key
0: No
1: Yes
0 0 Factory use only
Unique Switch h:4 - Operation
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Security reception after
printing Security Rx
document
0: Inactive
1: Active
2 1 The time for going back to
sleep mode after printing
received document
0: Immediately
1: After spending specified
time
1 0 The transmission time on
TCR
0: Print
1: Blank
0 1 Factory use only
Unique Switch h:5
Adjust
When the drum cartridge has reached its design life,
or the toner cartridge is empty, the machine prints a
consumable order sheet (see unique switch H:3).
When this switch is set at "0", the machine does not
print consumable order sheet until the current
printing job is finished.
When set to "1", Auto answer On/Off function will be
added to the functions which can be registered in
Soft keys.
Adjust
When set to "1", the security reception function
keeps to be active even after printing the security
reception documents.
When set to "0", the machine will immediately go
back to the sleep mode after printing received
document.
Note: This setting is effective only when the
machine was turned into the sleep mode by
pressing the Soft key.
When set to "1", it is after spending specified time
as the machine goes in the sleep mode normally.
Determine if the transmission time will be printed on
the TCR or will be blank.
i:6 --- Factory use only
3-60
Usage/Comments
Usage/Comments