Muratec MFX-1300 Field Engineering Manual page 37

Machine Parameter B:1
Initial
Switch
Setting
7 * Leading edge document
margin adjustment
6 *
(ADF)
5 *
4 *
Adjusts the leading edge
3 *
margin from the mirror
2 *
carriage passes End Sensor
1 *
to the start of the scanning
0 *
position.
Each setting changes
by 0.847mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Machine Parameter B:2
Initial
Switch
Setting
7 * ADF scanner registration
adjustment (Horizontal)
6 *
5 *
Adjusts the start point to scan
4 *
the document.
3 *
The plus setting increase the
2 *
left margin and the minus
1 *
setting decrease it.
0 *
Each setting changes by
0.5 mm.
Adjust
Switch 76543210
Adjust
Switch 76543210
3-7
Usage/Comments
Settings
00000000 0.00 mm
00000001 0.847 mm
00000010 1.694 mm
00101001 34.727 mm
(MFX-1300MFX-1200)
00101011 36.421 mm
(MFX-1700/MFX-1600)
11111110 215.138 mm
11111111 215.985 mm
Usage/Comments
Settings
00000111 3.5 mm Maximum
00000110 3.0 mm
00000101 2.5 mm
00000100 2.0 mm
00000011 1.5 mm
00000010 1.0
mm (MFX-1700/1600)
00000001 0.5 mm
00000000 standard
10000001 -0.5
mm (MFX-1300/1200)
10000010 -1.0 mm
10000011 -1.5 mm
10000100 -2.0 mm
10000101 -2.5 mm
10000110 -3.0 mm
10000111 -3.5 mm Minimum
Initial setting
Initial setting
Initial setting
Initial setting