Memory Module - Muratec MFX-C4000 Field Engineering Manual

7.2.2 Memory Module

Installing a memory module
Your machine has a dual in-line memory module (DIMM) slot. Use this memory module slot to install
additional memory.
Your machine has 320 MB of memory which can be expanded to 832 MB.
The order information is provided for optional memory module.
1. Turn the machine off and unplug all cables from
the machine.
2. Open the control board cover by grasping it and
slide toward you.
3. Completely open the latch on each side of the
memory module slot. Remove the preinstalled
memory module.
4. Take out a new memory module from the plastic
bag.
5. Holding the memory module by the edges, align
the memory module on the slot at about a 30-
degree tilt. Make sure that the notches of the
module and the grooves on the slot fit each
other.
Service Manual
Installation
1
1
1
control board cover
1
control board cover
7-14
6. Press the memory module into the slot with care
until you hear a 'click'.
7. Replace the control board cover.
8. Reconnect the power cord and printer cable, and
turn the machine on.
1
1
1
control board cover
1
control board cover