Only For Mfx-1700/Mfx-1600); Packaging Contents; Installation - Muratec MFX-1300 Field Engineering Manual

6.4 AL-200 (only for MFX-1700/MFX-1600)

Packaging contents:

(1) Second Phone Line Module — Includes the NCU and Modem PCBs................ 1
(2) Screws ................................................................................................................ 4
(3) Connection cable ................................................................................................ 1
(4) Telephone line cord ............................................................................................ 1
(5) Second Phone Line Module operating instructions............................................. 1

Installation

Note: Turn off the fax machine before proceeding.
1. Open the top cover. Remove the five mounting screws holding the rear cover in place. Disconnect the
speaker connector, and then remove the rear cover.
2. Remove the harness cover mounting screw on the rear cover. Then remove the harness cover.
You will pass the connection cable through this hole.
3. Remove four screws on the cover of the second phone line module. Then remove the cover.
4. Remove the angle plate mounting screw. Then remove the four angle plates.
harness cover
6-8