Muratec MFX-1300 Field Engineering Manual page 79

Unique Switch d:7 - Modem
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 The delay before post-
message is transmitted
3 0
(Only for MFX-1700/1600)
2 0 Factory use only
1 0 Factory use only
0 0 Factory use only
Unique Switch d:8
Unique Switch e:0 - Scanner
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 1 Factory use only
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 1 Hyper fine resolution
(Only for MFX-1700/1600)
0: No
1: Yes
Unique Switch e:1 --- Factory use only
Adjust
If retraining occurs due to the low reception signal
level and few delay of the telephone line, it may
overlap the second post-message. In this case,
increase the delay before the post-message is
transmitted.
Switch 4:
Switch 3:
d:9 --- Factory use only
Adjust
When set to "0", Hyper fine resolution (16
dot/mm) changes into Super fine resolution (8
15.4 dot/mm).
Note: Initial setting for MFX-1300 is "0".
3-49
Usage/Comments
0 ms 100 ms 200 ms
0 0 1
0 1 0
Usage/Comments
300 ms
1
1
15.4