Muratec MFX-1300 Field Engineering Manual page 54

Memory Switch B:5 - Transmission
Initial
Switch
Setting
7 0 Program individual autodialer
attributes
0: No
1: Yes
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Sending RTC signal when
transmission is canceled
0: Yes
1: No
1 1 Cancel redial if T.4.1 or T.4.4
error occurs
0: Yes
1: No
0 0 Action after EOR signal
0: Continue
1: Discontinue
Memory Switch B:6 - Transmission
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 1 Factory use only
3 1 Additional data on TTI
transmit
0: No
1: Yes
2 1 Subscriber ID transmit
0: No
1: Yes
1 1 TTI (name) transmit
0: No
1: Yes
0 0 Factory use only
Memory Switch B:7
Adjust
Allows individual setting of memory switches B:0 as
attribute 1, B:1 as attribute 2, B:2 as attribute 3 and
B:3 as attribute 4 when one-touch and speed dial
locations are programmed. (Refer to page 3-35 for
settings.)
RTC signal is sent at the end of the transmission.
When set at "0", the unit will send the RTC if the
transmission is canceled. No error will occur. When
set at "1", an error will occur because RTC will not
be sent at the end of a canceled transmission.
When set at "0", if a T.4.1 or T.4.4 error occurs, the
unit will not retry the transmission.
Sets action after receiving PPR four times at 2400
bps.
Adjust
When set at "0", the transmission of the additional
data (time, the number of pages, file number, etc)
is disabled.
Note: This switch is available only when Memory
switch B:2, bit 4 is available.
When set at "0", the transmission of the subscriber
ID is disabled.
Note: This switch is available only when Memory
switch B:2, bit 4 is available.
When set at "0", the transmission of the name
which was stored in the unit is disabled.
Note: This switch is available only when Memory
switch B:2, bit 4 is available.
B:9 --- Factory use only
3-24
Usage/Comments
Usage/Comments