Muratec MFX-1300 Field Engineering Manual page 50

Memory Switch A:5 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 1 Ring signal detect time
5 1
4 0
3 0 Number of rings
0: 1 ring
1: 2 rings
2 0 Dual ring detection
0: No
1: Yes
1 0 Long ring detection
0: No
1: Yes
0 1 Ring frequency detection
0: No
1: Yes
Memory Switch A:6
Adjust
Set the time that an incoming ring will not be
detected after hanging up. (Fax/Tel Ready mode
only.)
Switch 6 5 4
Sets the number of rings in Fax/Tel Ready mode.
Incoming calls are answered according to this
setting regardless of the number of rings chosen in
the User Settings. If Silent Operation is enabled, this
setting will change to 2 rings.
When enabled, the unit is able to auto answer an
incoming ring with an off time of 120 - 60 ms.
Allows the unit to respond to an incoming ring if the
ring on-time is longer than two seconds.
When disabled, the unit will not check the ring
frequency of incoming rings.
A:9 --- Factory use only
3-20
Usage/Comments
0 0 0 100 ms
0 0 1 200 ms
0 1 0 300 ms
0 1 1 400 ms
1 0 0 500 ms
1 0 1 600 ms
1 1 0 700 ms
1 1 1 800 ms